PINDA v2 BTT002 v1.0 about prusaaio HOT 6 CLOSED

Did you cut the diag pin on your Z driver? The PINDA won’t work with it attached.

Both the PINDA V2 and SuperPINDA work fine on the BTT002 boards here.

from prusaaio.

Did you cut the diag pin on your Z driver? The PINDA won’t work with it attached.

Both the PINDA V2 and SuperPINDA work fine on the BTT002 boards here.

do I need to cut diag on both tmc2209 z drivers

from prusaaio.

do I need to cut diag on both tmc2209 z drivers

The BTT002 only has a single Z driver. Are you sure you have a BTT002 motherboard?

The two drivers that need diag pins cut when used on the BTT002 are Z and E.

from prusaaio.

I think I was confusing another driver that was the E I've Been working on this since 6 am my brain is moosh lol

from prusaaio.

I will have to cut those pins or desolder them once I rewire my case

from prusaaio.

I've added some additional warnings during compile time about diag pins/jumpers and updated the Motherboards & Wiring Guide in the wiki with similar comments.

from prusaaio.