Problem using magic_switch component about esphome_components HOT 5 CLOSED

Try doing a clean build.

from esphome_components.

Thats in ESPHJome "Clean build files" then rebuild, right? I have done that with the same results.

from esphome_components.

For good measure I did it again and send the latest log attached.

logs_magic-switch-01_run.txt

I use the latest versions of all subsystems:
ESPHome 2023.12.9

HA versions:
Core 2024.2.1
Supervisor 2024.01.1
Operating System 11.5
Frontend 20240207.1

from esphome_components.

It looks like you have two copies somehow. Try deleting that build directory or re-install the addon.

from esphome_components.

OK. Found the problem.
I indeed had multiple files inside the ESPHome docker container from earlier attempts to have all files local.
Those attempts failed because the editor validator in ESPHome suddenly did not recognize the new magic-switch directive and I went back to referencing the Github repo. From the HA container it looked all was cleared but it was not in ESPHome.

I certainly learned a bit about the inner workings of ESPHome and where to look if there is an issue.
Nothing for the faint hearted though :-)

Thank you very much for your help and the great work you do for the HA and ESPHome community.

from esphome_components.