Wrong Status of Fibaro Dimmers about homebridge-zway HOT 5 CLOSED

Well, actually if you have a look at your fibaro dimmer definition/settings you will read the following:
You can set a dimmer value between 1%-99% where 1% is equally to off and 99% full state.
So I assume there is not really a problem, it's just a matter of different definition. And per definition it means that a value of 1% seems to be simply "off"....

from homebridge-zway.

OK, then I have to precise this: It also does not work between 2% and 6%.
In the Razberry front end it shows the correct percentage. In Homekit it shows "off"...

from homebridge-zway.

Hi @TS-Tec ... Whoops! This is a documentation omission.

The behavior you're observing is a "feature", that was more necessary in Z-Way 2.1 (I think) and earlier, where a dimmer's final status would not always be properly reported--that is, if a dimmer started ramping down to 0%, it might appear stuck at some small percent in the Z-Way interface. They changed/fixed this behavior in Z-Way though, so it's a bit unnecessary now.

You can change this behavior by setting a value for dimmer_off_threshold in config.json, and it sounds like you'll want to set it to 0. I will update the documentation to include this feature, but it should work already, since the first 0.5.0-alpha release, I think. See also #31 and commit 3f1420e.

from homebridge-zway.

@SphtKr That's it! Works fine now!
Can you tell what is the default value if this parameter is not set in config.json?

from homebridge-zway.

Yes, it's 5.

from homebridge-zway.