Feature request: No pulse failsafe option about rc_rx_cabell_v3_fhss HOT 7 CLOSED

Thanks for your suggestion.

Can you provide more details on how this would need to be implemented? Are we talking about the SBUS output or the servo outputs?

SBUS has a fail-safe flag in the packet, and the receiver sets this flag appropriately on SBUS output when there is a failsafe. Iis this what no-pulses is supposed to do? Do you know if flight controllers honor this flag?

from rc_rx_cabell_v3_fhss.

Just stop sending signals to the flight controller in ppm mode;
Cleanflight and Betaflight honor the sbus fail-safe flag, the cleanflight community has implemented it, cleanflight/cleanflight#2549

from rc_rx_cabell_v3_fhss.

I just uploaded a new version with no-pulses capability. It seems to work but has very limited testing at this point. Please test if you can. You will need to use my fork of Multi-protocol with the latest RX code as I have not merged my MultiProtocol changes back yet. In this mode both PPM signals and SBUS signals are stopped on failsafe.

from rc_rx_cabell_v3_fhss.

OK, i will test it later.

from rc_rx_cabell_v3_fhss.

I have tested the latest firmware, the no-pulse works as expected.

By the way is the D4 ( SchematicWithDiversityWithSBUS.png ) optional if only one module is connected ?

from rc_rx_cabell_v3_fhss.

Thanks for testing it.

Yes, D4 is not needed if only one NRF24L01 is connected

from rc_rx_cabell_v3_fhss.

Closing as this feature is complete

from rc_rx_cabell_v3_fhss.