Ability to run server-only on Raspberry Pi, connect from remote client about gsender HOT 4 CLOSED

I know this ticket is from December, but this sounds really appealing, especially with the new AutoZero touch plate. I'd buy that in a second if I could use it with a headless gSender, but my current setup (also with cncjs) depends on a headless raspberry pi.

Since I'm not familiar with the code, could a maintainer comment on how complicated this would be to implement?

from gsender.

I think this already works, just launch gsender with options -H 0.0.0.0 and -p 8080 to set listen address and port. You can pick interface IP and port as needed and launch on raspi? (I only tested on windows and that worked fine for me)

from gsender.

Since this is closed as completed I tried gSender 1.2.1 EDGE.

gSender -p 8080 -H 0.0.0.0 --remote --allow-remote-access

But I am a little confused.
Despite --remote it still opens the UI.
And the --allow-remote-access does not seem to be required?

Is there any documentation on this yet, @kglovern ?

from gsender.

I too am interested on the current status of --remote because anything newer than 1.2.2 EDGE is having issues on my RPi, but 1.2.1 and 1.2.2 do seem to work after some encouraging, but like you describe, still opens the UI. Is this what --kiosk mode is brought in version 1.2.4?

from gsender.