large battery capacity about scarab-osd HOT 12 CLOSED

Hi - yes, this is the designed limit. At the time of design such large batteries were unimaginable!! You are the first to reach the limit. Congratulations !!

I will look to implement as you describe. It will probably have to be 10.1Ah, 10.2Ah etc.
It will be a few weeks as I am away shortly.

I will post update here when it is completed.

from scarab-osd.

Thanks for quick reply! Yes, I was first with question about 12S LiPo battery voltage and now capacity is around 64Ah. It will be fine with 1 digit after point, no problem. I'm glad it is possible at least and you are healthy and online! Thank you, good luck!

from scarab-osd.

BTW - can you share a bit of info about your aircraft? 12s / 64AH sounds very interesting!!

from scarab-osd.

from scarab-osd.

OMG. It is huge.
I have large tricopter that is 1m between motors and 15 inch props and is the biggest have ever seen

from scarab-osd.

Hello! I hope you are fine! This question is still actual for me. Thank you!

from scarab-osd.

Hi - sorry for delay - it is not forgotten - I have just been busy with day job and finishing off another development project.

MAybe 4 weeks I will be free to complete

from scarab-osd.

Hi! How are you? This thing is still actual for me. Now I'm using ver 2.0 pre release, also added GPS Alt and Baro Alt and both are not correct when GPS signal is lost

from scarab-osd.

Hello, is this still required. Today I found my development unit after 1 year in storage so will be completing a few requests
If yes, does the amp draw display correctly? And what is the maximum amp draw approx of your drone

from scarab-osd.

Hi - this is done.
It is not available in pre-compiled binaries that can flash from GUI until next release. If this is an issue, or not sure how to build your own using arduino, please re-open.

https://github.com/ShikOfTheRa/scarab-osd/wiki/Custom-installation-guide

from scarab-osd.

Thank you! Now it is mismatch with the simbols mAh to Ah. I can draw Ah instead of mAh, but up to 9999mAh there is no "m" letter, like meters in distance ot altitude values. Interesting challenge for me =)

from scarab-osd.

Hi - here is a temporary solution. It is not available in pre-compiled binaries that can flash from GUI so it will require:

1 Custom installation ( flash using arduino )
https://github.com/ShikOfTheRa/scarab-osd/wiki/Custom-installation-guide

2 Load fonts (Edit, load font from file, and select file from fonts folder in zip file below)

https://github.com/ShikOfTheRa/scarab-osd/archive/refs/heads/Battery-display-AH.zip

I am not planning any more updates for MWOSD. It is near end of life with very little capacity and also the number of users have reduced as they migrate to newer platforms. MWOSD will probably remain static now for many years.

from scarab-osd.