Possible to use high-speed PWM pin 11? about mozzi HOT 4 CLOSED

On 3 Dec 2017, at 1:57 pm, ilia onic ***@***.***> wrote: I have a module using pin 11 for output ( phase-correct ). Current code looks like: #define PWM_PIN 11 #define PWM_VALUE OCR2A // called in setup void audioOn() { // Set up PWM to 31.25kHz, phase accurate TCCR2A = _BV(COM2A1) | _BV(WGM20); TCCR2B = _BV(CS20); TIMSK2 = _BV(TOIE2); } SIGNAL(PWM_INTERRUPT) { // get output value logic.. PWM_VALUE = output; } Having hard times figuring out how to run Mozzi on it. Is it possible? Sorry if noob question or unrelated. — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#34>, or mute the thread <https://github.com/notifications/unsubscribe-auth/ABttN3fceSwqV6MISU0v-c-1vthvNqVgks5s8prMgaJpZM4QztXj>.

On 3 Dec 2017, at 5:15 pm, ilia onic ***@***.***> wrote: Hi Tim, Sorry if it's not clear. I have Ginkosyntese Grains and it is using PWM pin 11 ( i.e. https://github.com/attejensen/grains/blob/master/sqr_osc/sqr_osc.ino#L34 <https://github.com/attejensen/grains/blob/master/sqr_osc/sqr_osc.ino#L34> ) ( using Arduino Nano ) I was looking into reconfiguring Mozzi to use pin 11 instead of suggested 9 but no luck. // known_16bit_timers.h #elif defined(__AVR_ATmega168__) || defined(__AVR_ATmega328P__) #define TIMER1_A_PIN 9 #define TIMER1_B_PIN 10 #define TIMER1_ICP_PIN 8 #define TIMER1_CLK_PIN 5 Not sure whether something else need to be reconfigured in Mozzi in order to use that. — You are receiving this because you commented. Reply to this email directly, view it on GitHub <#34 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/ABttN5VRdLtqumz4BaQhPAiu607NT7GWks5s8skUgaJpZM4QztXj>.