After recording a macro some functions stop working about ds4windows HOT 8 CLOSED

I had encountered similar problems when finding the problem with the multi-action button feature. At that time, I was just concerned with getting that action type working again so I need to go back and check this.

from ds4windows.

I am looking into this again. After testing recording macros a bit, I have not been able to encounter the problem that I had experienced before. Maybe changes fixed this problem but more testing will have to be done just to make sure.

Edit: The listed use case also works now.

from ds4windows.

New test build

https://drive.google.com/open?id=0B6yGHDx0CFzDQkJyZUtRN01WWkU

from ds4windows.

I think this is still not 100% fixed.
Did did a test on the multi-action button macros.
After recording a macro the Lightbar still stops working.
Tested on 1.4.76

from ds4windows.

I will re-open this issue for the time being. However, I cannot duplicate the problem on my system. The only thing that I can look in the code for is a time where the recording macro flag is not reverted. That flag still being set would be the most likely culprit for this problem occurring.

from ds4windows.

Here is a profile to test this issue:
DS4_Steam.xml

Pressing the PS button change lightbar to blue.
After recording a macro pressing the PS button will not change the bar color.

from ds4windows.

Can you share your Actions.xml file as well? That will be needed to test the bound special actions.

I only looked around at this today and there were circumstances when the recordingMacro flag would not get reset. That would cause all special bindings to not work. I just made a small change to explicitly reset the flag when closing that form instead of relying on the status of the recording button. It should be enough to work around the problem. I can post a test build in a little while.

from ds4windows.

Yep the test build is working fine after recording macros!
Cheers!

Here is my actions profile:
Actions.zip

from ds4windows.