whether the calculation results in the MGWR and GWR4 are the same? about mgwr HOT 2 CLOSED

Hello @binbin110,

It may be slightly different if you use golden-section search since the lower and upper bound are different than theses in GWR4 (well, I suspect this, but I don't have access to the code in GWR4). The results should be consistent if you use a pre-defined bandwidth. If you do see other differences, feel free to attach a copy of the data, I could look into this.

Cheers,
Ziqi

from mgwr.

Hello @Ziqi-Li ，

Thanks for your reply. When i use MGWR software(golden-section) to calculate GWR , it will report an error, as the picture,.When i use the pre-defined bandwidth( last bandwith in error) to calculate ,it can run . Whether the last bandwith in the error is the best bandwidth ? whether i can use the bandwith(the last bandwith in error) to calculate?

Best regards，
Jianbin

from mgwr.