Comments (20)
I've already fixed Kosodate Gokko booting properly (a stupid bug) and managed to successfully copy the Volleyball disk to a clean fds. I'm checking out another thing I discovered during the debugging session.
from punes.
After this f540b5b I can considered closed this issue.
from punes.
Hi @TakuikaNinja, thanks for the report, can you kindly send me the FDS of Kosodate Gokko? I don't know when I'll be able to take a look at it, in this period I don't have time to dedicate myself to the emulator but I will do it as soon as I can
from punes.
I'd rather not send the FDS file, even if it's technically abandonware. It shouldn't be too hard to find it in a nointro dataset anyway.
from punes.
question: is the available image for this game even playable by itself to begin with? or does it need some other data/disks like the video shows.
from punes.
Based on the rudimentary analysis I did, the image does contain everything required to load/run the main program (aside from the disk to copy from and the blank disk to copy to, of course). It's just that it bypasses the normal BIOS disk I/O routines and directly uses the IRQs generated by the disk drive to transfer each byte. The main program uses the same method for its disk transfers, so getting this right is essential for getting it to copy disks correctly.
from punes.
Admittedly, this protection is actually simpler than Jingorou (which finds/loads a block type of 0 from within a mess of data). The main program code in Kosodate Gokko is prefixed with a $12 byte in the image and is sandwiched by mostly blank padding.
from punes.
"disk to copy from" <- what is this disk? and is the data in this particular image we are talking about? coz the game data for this file is just 65500, or one side. so it this just the loader or sort and does not contain actual game data?
from punes.
"disk to copy from" <- what is this disk? and is the data in this particular image we are talking about? coz the game data for this file is just 65500, or one side. so it this just the loader or sort and does not contain actual game data?
It's an arbitrary disk. Have you forgotten what a disk copier does...? You load up the copier (e.g. Kosodate Gokko), swap to a different disk to copy from, then swap to a blank disk to copy the disk to. This was one of many backup utilities from the FDS' commercial lifespan, which ended up being riddled with casual and commercial piracy.
As I've said, the image for Kosodate Gokko contains the copier code we need. It's just loaded in an unusual way which emulators haven't emulated properly. Is that clearer now?
from punes.
One thing I noticed is that it copies a maximum of three files, if the fds is made up of more than 3 files from the fourth onwards they will not be copied.
from punes.
I think the intention might have been to make the user swap disks back to copy all of the data? I've been disassembling the code myself and found that it does have a limit of $2A for the number of loaded file headers. 3 files is well below that, so maybe it's checking the buffer size and prompts for swaps accordingly? I'll see if I can find the manual for it.
from punes.
Yes, I really think that the limit is not the number of files but the size of the buffer. In the video I seem to see that at the end of reading the source disk and at the end of the destination disk there is a flash of the screen which does not happen in the emulator. Reading and copying happen correctly but not that flash.
from punes.
The flashing seems to be done by toggling the grayscale mode (bit 0) and emphasis (bits 7-5) in PPUMASK while rendering is disabled. It isn't tied to vblank.
from punes.
Fixed with ebc8f54, thx for the info.
from punes.
One last thing remains, in the video, when the disk to be copied is inserted, the drive motor turns off when the screen starts flashing while in the emulator the head performs another scan of the disk (without carrying out any actual reading) before stop. I tried to understand why but I couldn't. I simulated the compartment seen in the video by setting a Disk IRQ when reaching the end of head but I found no mention of such a thing in any documentation. In addition to the classic conditions that lead to the engine stopping, I found no other reasons to stop it at that moment.
from punes.
I think it has to do with the routine used to wait for the disk to be ejected. Here's the disassembled section:
; stop disk drive motor and wait until the disk is ejected
; the greyscale mode is toggled to indicate this
WaitForEject:
028F AD 32 40 L028F LDA DRIVESTATUS
0292 29 02 AND #$02 ; check disk ready flag
0294 F0 05 BEQ L029B ; branch if ready
0296 A9 2E LDA #$2E ; stop motor, reset transfer timing
0298 8D 25 40 STA FDSCTRL
029B A2 0A L029B LDX #$0A ; init counter
029D A0 78 L029D LDY #$78
029F 20 39 02 JSR Delay ; wait for some time
02A2 E6 FB INC $FB ; this toggles the grayscale bit
02A4 A5 FB LDA $FB
02A6 29 E1 AND #$E1 ; disable rendering but keep emphasis/greyscale
02A8 8D 01 20 STA PPUMASK
02AB AD 32 40 LDA DRIVESTATUS
02AE 4A LSR A ; check disk inserted
02AF 90 DE BCC WaitForEject ; branch to loop if inserted
02B1 CA DEX
02B2 D0 E9 BNE L029D ; loop until counter reaches 0
02B4 60 RTS
The motor is only stopped when the disk is "not ready", which I believe corresponds to the drive head moving from the end of the disk back to the start. The video actually shows the screen flashing before the motor is stopped once it finishes writing to the blank disk.
I think we're done here.
from punes.
Thank you very much for the piece of code, it is extremely useful to me. I would like to ask you, if it were possible, to see the routine that takes care of reading the source disk up to WaitForEject, it could help me a lot. If you can't it doesn't matter, I still thank you for the feedback, you helped me improve the quality of the emulation.
from punes.
I'll attach my WIP disassembly of the copier program. Hope that helps!
copier.asm.zip
from punes.
🙏 Many thanks, it will help me carry out a complete check.
from punes.
Ok, thanks to your copier.asm I found and fixed (5448b15) the problems concerning the disk change and which did not allow the correct copy of the FDS which required multiple changes between the source disk and destination disk. I tried multiple FDSs and always got a working copy of the source disk. Thank you so much.
from punes.
Related Issues (20)
- HeaderLess (Unheadered) ROMs not working HOT 3
- NSF returns Unknown OPcode F2@E002 HOT 4
- NSFE: music plays strange after changing the track from one to another HOT 4
- [Question/Improvement?] APU: DMC and Konami games HOT 2
- [NSFE] Illegal opcode 0xF2@0xEFFE HOT 4
- Jikai Shounen Met Mag - error loading save states HOT 6
- Compilation failure with disabled FULLSCREEN_RESFREQ HOT 1
- N163 sampler volume question (NSFs attached) HOT 3
- Problems with some cgp shader HOT 2
- m342: typo
- Set gamepad ID via command line HOT 2
- m176: submapper1 issue in new dumps HOT 3
- TAS System; Where is it? HOT 3
- mapper 17, submapper 3 : possible buffer overflow HOT 2
- Famicom Network Controller (HVC-051) HOT 3
- Fullscreen doesn't work on Wayland HOT 1
- Celeste Mario doesn't run // MMC5 accuracy issue HOT 1
- m176: new dump in iNES format is submapper 1 HOT 1
- Screen Settings Menu Clarity HOT 1
Recommend Projects
-
React
A declarative, efficient, and flexible JavaScript library for building user interfaces.
-
Vue.js
🖖 Vue.js is a progressive, incrementally-adoptable JavaScript framework for building UI on the web.
-
Typescript
TypeScript is a superset of JavaScript that compiles to clean JavaScript output.
-
TensorFlow
An Open Source Machine Learning Framework for Everyone
-
Django
The Web framework for perfectionists with deadlines.
-
Laravel
A PHP framework for web artisans
-
D3
Bring data to life with SVG, Canvas and HTML. 📊📈🎉
-
Recommend Topics
-
javascript
JavaScript (JS) is a lightweight interpreted programming language with first-class functions.
-
web
Some thing interesting about web. New door for the world.
-
server
A server is a program made to process requests and deliver data to clients.
-
Machine learning
Machine learning is a way of modeling and interpreting data that allows a piece of software to respond intelligently.
-
Visualization
Some thing interesting about visualization, use data art
-
Game
Some thing interesting about game, make everyone happy.
Recommend Org
-
Facebook
We are working to build community through open source technology. NB: members must have two-factor auth.
-
Microsoft
Open source projects and samples from Microsoft.
-
Google
Google ❤️ Open Source for everyone.
-
Alibaba
Alibaba Open Source for everyone
-
D3
Data-Driven Documents codes.
-
Tencent
China tencent open source team.
from punes.