Error Configuring Multi-Channel Aurora NDI Tools about pluslib HOT 4 OPEN

NDI PortName and RomFile are both specified for tool DistalToEmTracker. Assuming broken wired rom, using virtual rom instead

You shouldn't specify RomFile for wired tools. Does removing RomFile for the Distal and Proximal tools fix the issue?

from pluslib.

This is a custom tool assembly wherein NDI's sensors are soldered by us to their tool cable assembly. I believe it will necessary to define the ROM somewhere.

Removing it causes a different error: "Unable to initialize Tool-in-Port. errnum: 19| in E:\D\PSNP64b\PlusLib\src\PlusDataCollection\NDICAPITracking\vtkPlusNDITracker.cxx(684)"

Here's the logfile.

Only changes to the config are the removal of the the RomFile parameter from the "Distal" and "Proximal" DataSources.

from pluslib.

For the sake of anyone with the same issue in future: I was unable to configure this as described in the docs. The only thing that worked was wiring up two fully separate ports, ie one port for each sensor. Multi-channeled user-wired tools, such as NDI's smallest magnetic sensor, (0.3mm x 25mm 5DOF) do not seem to be supported.

from pluslib.

If you can record the COM port trace from NDI Track and send us the log, we can look at it to see what commands it sends and then compare that to what PLUS sends.

from pluslib.