Update the DCF77 Clock Sync app for the SDK version 0.97 f7 about dcf77-clock-sync HOT 9 CLOSED

fixed in #3

from dcf77-clock-sync.

fixed in #3

No, it was not... DateTime needs to be fixed.... could you advise how this app works differently than this one?

from dcf77-clock-sync.

The other app doesn't work for me...

Not sure if the RFID transmission frequency is wrong or at some point it stopped transmitting at all. Have you tested it?

Besides this, I’ve improved the timing so the sync is always successful in 2-3 minutes.

And finally I am sending the signal including carrier frequency using PWM over the GPIO pin, so that with proper antenna the range could be increased greatly.

from dcf77-clock-sync.

I was able to compile the new version with 0.97.0-rc, what do you mean with DateTime?

from dcf77-clock-sync.

See here all the changes you will need for DateTime and also formatting :)

from dcf77-clock-sync.

P.S. All flipper projects use the GPLv3 license

from dcf77-clock-sync.

ah.. this works for RogueMaster but would be incompatible with the official firmware...
Thanks for the update!

from dcf77-clock-sync.

ah.. this works for RogueMaster but would be incompatible with the official firmware...
Thanks for the update!

With the changes that I provided it should become compatible with the official dev version

from dcf77-clock-sync.

should be fixed in #5 😉

from dcf77-clock-sync.