Compare tab - bug 2 about airsensordataviewer HOT 4 CLOSED

I would suggest that there is some distance at which a comparison is inappropriate.

To my mind, a more appropriate choice would be a "status message" on the plot explaining why the reference data is not shown.

from airsensordataviewer.

Want to have things show up even if it is 30km away.

Have a disclaimer beyond a certain radius. (collocation, pseudo-collocation, ...)

Always include time series plot and table even if discarding scatter plot.

from airsensordataviewer.

The furthest distance between a STAR Grant sensor and reference instrument is ~23 km, so even if we extend the limit to 25km this will ensure the plots in the "compare" tab are generated for all STAR Grant sensors.

Could the current text in the pop-up help box in the "compare" tab be replaced with the following text:

"Select a sensor to compare to the nearest reference site by clicking on the map or by using the drop down menus in the panel on the left, then select a date range of interest.

The plots below the map illustrate similarities and differences between the data from the sensor and the nearest reference site (with continuous PM2.5). Note, the distance between the reference site location and the sensor location by viewing the map and as stated in the title of the “Sensor/Monitor Comparison” plot. When comparing these two datasets, consider the distance, the topography, and local sources – all of these factors can help to drive differences and similarities in the data from the two sites.

In terms of the statistics, a slope close to 1.0 indicates that the low-cost sensor and the reference site are reflecting similar levels. A slope greater than 1.0 indicates that higher values are seen at the regulatory monitoring site and vice-versa for a slope of less than 1.0. The intercept can be an indicator of bias. The coefficient of determination R2 tells us how well the trends agree between the two sites; an R2 closer to 1.0 indicates more agreement and an R2 closer to 0.0 indicates less agreement.

The table showing the number of measurements and percent of the data recovered provides insight into how well the sensor is functioning. For example, if the percent of data recovered is small, then this may be an indication of an issue with the sensor."

from airsensordataviewer.

Sure thing! The distance has been extended to 30km.

from airsensordataviewer.