Cannot establish Communication about rf24 HOT 3 OPEN

I've got exactly the same problem.

Let me point out that each time you try to send a message with the code from the lib's examples, you can get two different "fails".
Ex. : "Now sending 3411559399...ok...Failed, response timed out." -> ok / error
but on your arduino : "Now sending 8286...failed. Failed, response timed out." -> error / error

I've got the same issue on a nano. The worst thing, it has worked before with the exact same setup ...

from rf24.

I was running into the same issue. However, adding a 10uF capacitor between the Vcc (3.3V) and GND did the trick. Apparently the 3.3V regulator is not stable enough and adding a capacitor between those two reduces the jitter.

All the best!

from rf24.

+1 sparupat, I using it

from rf24.