Can I avoid the use of NRESET and FTDI? about pymmw HOT 2 OPEN

Hi, there are three ways of doing a reset: 1) pressing nrst, 2) via ftdi of the carrier board, 3) via the xds interface of the board itself. Unfortunately, the most straightforward way doing a reset with the xds is dependent on the actual type of device, so the exact procedure differs a little from one type of device to another. As I was able to look into the details about doing a reset on the IWR1443 since this was my setup, I did not spend too much time on other devices. Having that said, yes, it is possible to do the reset on your device with the XDS not pressing NRST or using FTDI, however it is not supported by pymmw yet.

from pymmw.

Thanks for the quick comment @m6c7l. Do you mind to let me know how the reset 'with the XDS [without] pressing NRST or using FDTI' was implemented in your setup?

I do understand that it is not supported yet in this package. But maybe I could borrow some ideas from you? Just maybe also that the implementation can be done for IWR6843 same way you did for IWR1443.

from pymmw.