RF sending about homebridge-broadlink-rm HOT 9 CLOSED

In issue #11 you said you were seeing an error, did you get any further than this?

from homebridge-broadlink-rm.

I solved the issue at issue #11, but the FR still not working. My IR is working, code learning also works..

from homebridge-broadlink-rm.

Ah I see, there's no support for RF at the moment, sorry. I'll need to create a learner for that so you can get the unencrypted hex code.

from homebridge-broadlink-rm.

I actually already extract the unencrypted hex code from my broadlink. I am working on that to see what can I make it work. Will update the status if it works.

from homebridge-broadlink-rm.

Okay, found the way to submit the RF and it is working now.

from homebridge-broadlink-rm.

@lily148 Was there anything special you needed to do?

from homebridge-broadlink-rm.

I extract the RF code using an Android device.
then when send code, I just duplicate the RF code in a single HEX data. Example as below.
RF for switch on= 091159103...
data: [091159103...091159103...]

This work perfectly.

If you can implement a RF learning then it will even better.

from homebridge-broadlink-rm.

@lily148 Have you tried just using the Learn IR method to learn RF? Supposedly it should work the same but I'm looking for confirmation

from homebridge-broadlink-rm.

I tried the normal Learn IR method, it is not working. As what I understand, RF learning should obtain the frequency first before it can proceed to learn the command.

from homebridge-broadlink-rm.