Consider Shelly as a digitalstrom replacement about homeassistant-config HOT 11 CLOSED

Shelly i3
Replacement for the wall switch terminal blocks.
To be released, No information about internals or open firmware yet
https://shelly.cloud/products/shelly-i3-smart-home-automation-device/

from homeassistant-config.

Progress report:

• Shelly 1 working great as a GE-KM200 replacement ✔️
• Shelly i3 waiting to be flashed as a SW-TKM200 replacement ⏳
• Shelly 2.5 waiting to be flashed as a GR-KL200 and SW-UMR200 replacement ⏳

from homeassistant-config.

Progress report:

• Shelly 1 working great as a GE-KM200 replacement ✔️
• Shelly i3 not working properly yet with ESPHome as a SW-TKM200 replacement ⏳
• Shelly 2.5 used as a SW-TKM200 replacement ✔️
  • Can be mounted easier than a Shelly i3 because it has no fixed cables attached
• Shelly 2.5 waiting to be flashed as a GR-KL200 and SW-UMR200 replacement ⏳

from homeassistant-config.

Could you post GPIO mappings for i3 when you have it? I'm waiting for my i3 and I just discovered ESPHome and love it.

I have Shelly1 running on ESPHome and RGBW2 in the works. RGBW2 works as a normal RGBW2 dimmer, but there are a few things I want to add such as dimming via momentary button press like Fibaro and figure out power consumption reads from A0 pin.

from homeassistant-config.

@matejzero sure. Here we go.

from homeassistant-config.

IN1 -> GPIO 13
IN2 -> GPIO 14
IN3 -> GPIO 12

from homeassistant-config.

The problem with the i3 currently is that the input seems to be floating ON/OFF and no pullup or nothing that I tried worked out.
Either no input or always floating on/off.
I'll now waste some more money and use 2.5s instead of the i3 as they're even more flexible without the hard-wired cables.

from homeassistant-config.

Thanks for the feedback. Too bad, I was really hoping i3 would work as it could solve most of my problems and the added input compared to 2.5 is great because of space problem.

I'll see what I can do with i3. Did it work OK with native firmware?

from homeassistant-config.

I'll see what I can do with i3. Did it work OK with native firmware?

Never tried with default firmware as I wouldn't run it with MQTT anyway. But as with all the other Shelly products, I would expect it to run properly on default firmware.

I'm also pretty sure there will be a way to get it working with ESPHome. It's just way beyond my level of experience.
Maybe wait a few weeks until some of the core ESPHome people got their hands on this brand new device.

from homeassistant-config.

Six devices to go:

• Garden shed water control (2x 2.5)
• Guestroom ceiling light (1x 2.5)
• Bedroom ceiling light (1x 2.5)
• Hallway lights (2x RGBW2)

from homeassistant-config.

Conversion done!

from homeassistant-config.