Non-standard config for Feather M0 about lmic-node HOT 4 CLOSED

Thanks for your feedback.

I must have forgotten to change it in the actual code (after changing it from 5 to 6 in the documentation).
Not having the hardware to test makes this easier to slip through.

Additionally, and I'm not sure if it makes a difference, but the examples also has .rssi_cal = 8, instead of 10.

Ah, I see, the 'feather-us915' examples use 8, while file hal/getpinmap_featherm0lora.cpp uses 10.
The 8 is possibly more correct. I'm not sure where you would see the actual difference. I suspect in reported RSSI value of downlink messages.

from lmic-node.

DIO1 mapping has been fixed.

Will have a look at rssi_cal later.

from lmic-node.

rssi_cal has been changed to 8.

from lmic-node.

Awesome thank you!

My initial testing with these settings got the device working with the expected serial monitor output. Tho I haven't been able to test on TTN as there are no active gateways near enough to me.

from lmic-node.