Fails, reboots when taking input, at the 'application' step about konnected-security HOT 6 CLOSED

update: I was able to get the system to work with the actuator devices. It's the sensors (0,1) that is contributing to the problem. When no 1/0 sensors are configured, and only actuator type devices are enabled, the system works and sends signals instantaneously.

from konnected-security.

Nate, any update/comments before I send my devices back for a refund?

from konnected-security.

Not to get too far into this but hace you tried just reflashing the firmware? I know when I have had an issue in the past this is the 1st thing I did and it always seemed to fix the issue.

from konnected-security.

I tried refreshing the firmware per these instructions... https://docs.konnected.io/security-alarm-system/upgrading

from konnected-security.

I had one board that was giving me some weird trouble so what I did was, from that page, the "Flashing Firmware: Windows Users" to make sure the firmware was good. I then used ESPlorer to connect to the device and I deleted every file off of it. Once everything was deleted I followed the "Manual Software Upload via USB" instructions to put the latest version back on. Rebooted and it has worked fine ever since. If it still doesn't work I'd say its a bad board but the fact its talking at all would lead me to believe there is just something messed up somewhere on it.

from konnected-security.

This problem is resolved in the latest Konnected firmware 2.2.0+

from konnected-security.