- Core files: (Required for ANY run)
	1) Makefile – This runs the fortran code and also, executes the “a.out” file.
	2) post107mb.f90 – This runs the postprocessing of the two flo.case1.##.dat (initial and final design case)
	3) Result_Out.py – This runs the macro in ParaView

- Input files: (Required for specific run)
	1) flo.case1.##.dat – design iteration input data files
	2) MBL1.CONN – connection file for each test case (used for extracting “-7”)
	3) output – output of the design iteration (used for extracting “RHO0, P0, U0, V0”)

1) Copy Makefile and post107mb.f90 to the test directory.
	- REMARK: Make sure the input files (referred in previous section) are all present
2) Run the following command: “make check”
3) Two files should be created in the current directory in the format of: Wing_Analysis_1.##.dat
4) Open ParaView
5) In the Menu Bar, click Macro -> Add new macro -> select “Result_Out.py”
	- REMARK: “Result_Out.py” can be located anywhere on your local machine
6) In the Menu Bar, click File -> Open -> select “Wing_Analysis_1.##.dat”
	- REMARK: Import the two Wing_Analysis_1.##.dat files from test directory
7) In the Menu Bar, click Macro -> click Result_Out.py
8) In the first window that pops up, input number of cross sections desired
9) In the subsequent windows that pops up, input the % - span location
	- REMARK: There should be as many subsequent popup windows as the inputted cross section number
10) Wait for Macro to run and obtain the desired Outputs.