Use just one key to switch between layouts about evsieve HOT 2 CLOSED

Yes. Just remove the =:number part after the toggle clause. By default, --hook toggle sets all toggles' active indices to the next one, wrapping around if necessary. The =:1 part of --hook toggle=:1 is to explicitly set all toggles to the first index instead of rotating them.

evsieve --input /dev/input/by-id/usb-Logitech_USB_Receiver-if02-event-mouse grab \
        --hook key:delete toggle \
        --block key:delete \
        --toggle "" @norm_layout @dev_layout \
        --map key:c@dev_layout key:leftctrl key:c \
        --map key:v@dev_layout key:leftctrl key:v \
        --map key:x@dev_layout key:leftctrl key:x \
        --map key:z@dev_layout key:leftctrl key:z \
        --map key:f@dev_layout key:leftctrl key:f \
        --map key:w@dev_layout key:leftctrl key:w \
        --map key:l@dev_layout key:leftctrl key:leftalt key:l \
        --output

(On a minor note: your input device looks like a mouse but the maps seem to treat it as a keyboard. Are you sure you've taken the correct input device?)

from evsieve.

Thanks a lot! My keyboard has a built-in touchpad. So system recognizes it this way. There're no other Logitech devices connected. Everything works fine though, remapping works perfectly.

from evsieve.