Lighthouses not showing up. about lighthouse_pm HOT 8 OPEN

Hi,
I'm having this problem on a Xiaomi Redmi Note 8T
Android 10 (crDroid custom ROM)

Under Bluetooth settings I can see them, but their names start with "HTC BS " followed by a six letter/number combination.

from lighthouse_pm.

@Mettanine I think those are the 1.0 lighthouses. Sadly the app doesn't support them since I don't have any to test them with. If you want to help you can have a look at #15.

from lighthouse_pm.

We had this issue when we tried to use two phones (Xperia xz1 compact and pixel 4) at once. We have base stations 2.0.
Specifically, one phone could find and control the lighthouses, the other couldn't find them
On the non-working one we tried:

1. Scanning multiple times
2. Closing the app by swiping in the recent apps chooser
3. Toggling Bluetooth
4. Force closing in the system menu
5. Deleting the app cache

Nothing worked. Then, on the working one we did:

1. Turn off Bluetooth
   From that point on, the non-working phone could see the lighthouses and control them.
2. On the (formerly) working one, we re-enabled Bluetooth and tried to use the shutdown button on one of the already scanned lighthouses. Didnt work. No error message, just nothing. Then, we tried re-scanning and nothing was found.

Looks to me like the lighthouses create some sort of connection and don't allow any other device to interact with them while connected.

from lighthouse_pm.

Not showing up on Samsung Galaxy A5 2017 (SM-A520F) running LineageOS 17.1 build 24 december 2020

from lighthouse_pm.

Why do I need to wait for the app to rescan known basestations every time I open it? Can it not remember known / named ones and just instantly offer me actions to turn it on / off? I get it very commonly where one or both basestations(v2) don't show up, even after multiple app restarts, forcing me to unplug and replug it, some times multiple times, until the app finally picks it up. Galaxy s6, android 7

from lighthouse_pm.

@kinsi55
The app needs to scan for devices in the area to figure out if they're lighthouses and connect to them. I can't just say connect to device 1 one and send the command. It has to scan for devices first, pick out device 1 from the list and then it can send commands.

Also if for whatever reason the app doesn't find the lighthouse anymore it's most of the time that the lighthouse thinks it's still connected to something and won't except new connections. So you'll have to wait for it to timeout or unplug/ replug it.

from lighthouse_pm.

But why would it require multiple power cycles of the base station? My index is disconnected from power when that happens so it can't connect to that.

Im aware you're working on a Blackbox(literally) here but for my use case of shutting down basestations whenever I forget to close steamvr before disconnecting the hmd power its a super frustrating experience. Also shouldn't the basestations be connected at all times while steamvr is running? Because some times while that is the case I go ahead and shut them down too as I just need the hmd to be there to debug something but tracking doesn't matter, and that seems to work fine most of the time. Regardless thank you.

from lighthouse_pm.

None of the troubleshooting steps helped. Restarting my phone did help though. Now it works again, just as a FYI, maybe you want to extend the troubleshooting steps.

Great Software, keep up the good work!

from lighthouse_pm.