How to customize the .xdmf file for initial conditions? about cylinder2dflowcontroldrl HOT 7 CLOSED

Hi,

I am not sure what you are trying to do so it is not so easy to help. But have you done the things as recommended in the readme, 'Making a new mesh' and 'To go further' sections? If you want to do something more sophisticated / outside of this range, this is not really the point of this repo and this would take me quite some work to develop and test myself, so I will not have the time for it.

from cylinder2dflowcontroldrl.

Thanks for your reply.
And yes, I followed 'Making a new mesh' section and had a new mesh model by running make_mesh.py. But after make_mesh.py generates the mesh files, it cannot conduct further calculations and the plot is just blank with probe points. And it gives *** Warning: Found no facets matching domain for boundary condition. Did I miss something? I'm thinking the problem maybe the p_init.xdmf and u_init.xdmf files or the boundary conditions.
Thanks!

from cylinder2dflowcontroldrl.

Strange. Can you post your full terminal output so that I have a look? Also, what exact configuration did you run? (i.e. can you join here a .tar of the files on which you run the make_mesh.py?).

from cylinder2dflowcontroldrl.

Also, can you go in details in the whole explanations here and try similar things? Unfortunately the singularity container was built without gmsh, so this is a bit hacky and some problems easily appear:

#4

from cylinder2dflowcontroldrl.

(i.e., can you look at issue 4, in link, which I helped the author solve, and may be the same as yours?).

from cylinder2dflowcontroldrl.

It turns out that I didn't define the jet correctly and that caused the issue.
Thanks for your time and advice!

from cylinder2dflowcontroldrl.

Perfect, great to know that it works now! :)

from cylinder2dflowcontroldrl.