ireshjayawardana Goto Github PK

100a-dc-motor-driver

This is my one iteration for building an high-performance motor driver. at this stage, a Half-bridge with 2 N channel MOSFETs and a gate driver is implemented. Necessary layout considerations were taken in order to avoid short-throughs and miller effect.

asic_lab2

ber-of-bpsk

simulation of Bit error rate on a noisy channel w.r.t SNR

compass_driven_stepper

this includes the arduino firmware to point a stepper driven platform to a given direction

e516_project

fpga-uart

Implementing a UART on FPGA and send and retire a image saved to its block ram

gitfirt

iresc_v1.0

This is firmware development tread for my ESC testing

ireshjayawardana

Config files for my GitHub profile.

lk_3d_skr1.4_v1.0

myfirst

test

podem-atpg

this is done for the completion of ECE 522 VLSI circuit testing

roboclaw-full

to use a roboclaw motor driver with HAL using stm32

simple-lung-sound-classification

smartstethoscope

repo containing the jupyter note books of my msc

solar-controller-wifi

ESP8266 based solar controller for inverter and changeover control

test

tflite_sinewave_cubeai

# tflite_SineWave_CUBEai This is the firmware to generate sin wave on a STM32f767zi nucleo board. Since STM have updated there APIs it now hard to use avalible examples for a newcommer to get into edge ai I used the following tutorial to get an idea, but the code explained in the turorial does not work with newer libraiers https://www.digikey.com/en/maker/projects/tinyml-getting-started-with-stm32-x-cube-ai/f94e1c8bfc1e4b6291d0f672d780d2c0 I Maneged to get it working buy refering the documentation of the cube ai package which gets downloaded to pc along with the library hope this helps