No throttle use displayed. (permanent 0%) about arducam-osd HOT 9 CLOSED

If you have a tlog for this flight, can you attach it? thanks

Hi, I do not have a .tlog for this flight, after upgrading to 1.9 - I wanted to 
test the OSD - not omit it's TX pin - and connect dronecell in paralell.
The problem is still reproducible on ground.

Please see attached file, not a flight log, but smaller, just as good.
I booted APM + OSD - and watched OSD (stuck at 0%) while moving throttle.most 
of the log have some throttle, there should be little time at 0%.
I can test a bugfixed version anytime.

Did you calibrate your radio? I can't reproduce it here.

yes, it's calibrated - what about the tlog ? - it shows min/max value, and you 
calculate % ? 

Yes. TLog isn't using just the MAVLink HUD msg data. Anyway, I can't reproduce 
it here. It's working fine with latest ArduPlane code.

guess what : I erased APM settings - and it worked. - does not work if I import 
old config - but it works with new config.  very strange.

if you care to pinpoint the problem - see the attached config.
the config ended up as a mess after much testing, so I decided to do it all 
from scratch - except for the PID's I knew were good, and voltage/current 
calibration.

Yes. Wrong data on ch3 trim parameter can drive to errors like that. So, that's 
not about the OSD and I will set the status to invalid. Anyway, thanks by your 
feedback.

ok, all the ch min/max values seem to be lost, that must have happened when I 
played with partial import (view difference) - this config would not have 
worked with AP at all.
Anyway - case closed :)