About“paused” need help about axidraw HOT 19 CLOSED

Which version of the AxiDraw software are you using?

from axidraw.

Looks like you edited to say “every version”

from axidraw.

Is the pause button physically able to move; does it click up and down? Does the pause button work correctly otherwise?

from axidraw.

Pause button work ok.

from axidraw.

When the AxiDraw software runs normally, it can be paused by the pause button.

from axidraw.

Before each normal use, must run:SC,13,0\r

from axidraw.

If you reset the EBB does that command still need to be run to get normal operation?

from axidraw.

Yes

from axidraw.

I'd suggest updating to the current firmware 2.5.3, just to see if that makes any difference.

from axidraw.

Is this a hardware problem？

from axidraw.

After the upgrade 2.5.3, the same question was asked. “Plot paused by button press after node number 0.”

from axidraw.

from axidraw.

RB0 is empty.

from axidraw.

from axidraw.

When I first had a problem, I checked 'ebb.html' and knew that RB0 was alternate pause button , so I tried it through the SC command, after running "SC,13,0\r", inkscape can be used normally. But restart after Shut Down , the problem arose.

from axidraw.

I send the command "PI,B,0" and get back "PI,0".

from axidraw.

I think I ran into a hardware problem.

from axidraw.

I need to check the motherboard carefully. Thank you EmbeddedMan and oskay !

from axidraw.

OK, closing this for now. (Hardware, not software.) If the issue appears to be software related after all, please feel free to reopen.

from axidraw.