totally new left joycon PCB about nintendo_switch_reverse_engineering HOT 5 OPEN

Hi if you want i got some of the soldering point for the buttons (sorry for the picture quality i don't have a microscope)

ÉDIT, WARNING : misreading, I inverted pot x and pot y on the picture

from nintendo_switch_reverse_engineering.

You had a pic here, why you removed it?
It was valuable.

It is indeed a redesign. Antenna is now at the bottom instead at top protruding.

• The antenna is signal separated with plated through holes. It now uses a different design.
• The baseband is now Cypress branded.
  (Broadcom bt part was owned by Cypress, even back then, Nintendo had the time to source millions of these.)
• It seems that IMU and SPI chip are now under the board
• Finally the new revision is called JCL-M-11 instead of JCL-M-01

So you may want to try to buy older ones to use as much information from this repo as possible.

That's partially incorrect. The only thing that someone needs to do, is find the new pad positions, nothing else. And that's, if probing.

from nintendo_switch_reverse_engineering.

thanks for the update @CTCaer.

i've uploaded the image again here. the first round i forgot to delete all the EXIF metadata :).

from nintendo_switch_reverse_engineering.

@vic1707 is it possible using these pads with external MCU to press the buttons ?

from nintendo_switch_reverse_engineering.

I don't know, I haven't touched this for a while 😅

from nintendo_switch_reverse_engineering.