I create a nose cone with the following parameters: blunted ogive (no shoulder)<br

blunted ogive cone deformed about rocket HOT 4 CLOSED

Arogen commented on May 13, 2024

blunted ogive cone deformed

from rocket.

davesrocketshop commented on May 13, 2024

Short answer is that the workbench has no control over the STL generation. That's done by FreeCAD.

The good news is that the defaults aren't well suited to nose cones, or curved surfaces in general. Please read this thread for a discussion: #25

Try playing with the defaults. If that doesn't fix the issue let me know.

from rocket.

Arogen commented on May 13, 2024

Thanks, that's what I needed.

from rocket.

davesrocketshop commented on May 13, 2024

I think I need to do a video on this. I know you're not the only one who experiences this, and the fix while simple is not obvious.

Glad it worked for you.

from rocket.

Arogen commented on May 13, 2024

A video would be good. Point out that by changing those settings the file size increases (I assume the triangle count increases too). I was planning to do some post processing in Tinkercad but couldn't due to its size/triangle limits. Paul From: David Carter ***@***.*** Sent: May-25-22 9:34 PM To: davesrocketshop/Rocket Cc: Arogen; Author Subject: Re: [davesrocketshop/Rocket] blunted ogive cone deformed (Issue #30) I think I need to do a video on this. I know you're not the only one who experiences this, and the fix while simple is not obvious. Glad it worked for you. — Reply to this email directly, view <#30 (comment)> it on GitHub, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AIQZJ4NDMAZGKSHTFOCVBODVL3IHPANCNFSM5WXWZGDA> . You are receiving this because you authored the thread. <https://github.com/notifications/beacon/AIQZJ4JZETYPER4E5AC5BITVL3IHPA5CNFSM5WXWZGDKYY3PNVWWK3TUL52HS4DFVREXG43VMVBW63LNMVXHJKTDN5WW2ZLOORPWSZGOIPKTUII.gif> Message ID: ***@***.***>

-- This email has been checked for viruses by AVG. https://www.avg.com

from rocket.

Recommend Projects