Branch RTL _433 on ESP32 is craching after some time (Master is working fine) about rflink32 HOT 4 CLOSED

Hi,

Your explanations are a bit confusing sorry.
What is the error logs you pasted earlier? The Upgrade logs or the Crash logs?

from rflink32.

Hi, sorry for the confusion.

The first Log comes from my Domoticz installation.
Do not worry about this one.
I just wanted to show, how the behavier lokks like.
So the ESP32 device is running ~ 3 Minutes and than it is stopping communication.

The second one is the crash log when I try to update over the Web Gui of the ESP32 device from RTL_433 back to Matster version.

So I uploaded the master version over USB cable.

Since opening the issue, the same device is now running stable with the master version, so the hardware and power supply seems to be OK.

There is no crash log when I run the RTL Version, it is just stopping the communication and it is not reach able over the WEB-GUI, but can be still ping in the network.

Hope this helps a little bit more.

One thing, the inFactory-TH sensor. is sending ~8 times the same message and I have two of them.
Maybe some kind of buffer overflow? As I am not a expert is is just guessing.

Br. Frank

from rflink32.

It's normal for devices to send their messages a few times, they all do that for various reasons.

RTL433 version pushes the ESP32 to its limits in term of memory and also it is much much less tested (fewer people is running it) so instability is not surprising at this stage.

Did you enable RFDEBUG mode so we can first check what signals are captured by the Radio? based RTL_433 plugin for your device, our default limit of 5000ms could be too small and may require a few tweaks for your specific protocol. Would be nice to see what your signal looks like, you could even write a native plugin for your device

from rflink32.

Hi, I will enable RFDEBUG and come back with the result, but it will take a while.
I am not a programmer, so I will not be able to write a plugin, sorry.

from rflink32.