Format needed for Secrets.h about goprocontrol HOT 4 CLOSED

Hi I am very new to Github, Arduino and WiFi. Sorry in advance for some some of the stupid questions I may be asking. . . . . I make YouTubes with up to 3 GoPros (1xHERO6 and 2xHERO8). See channel https://www.youtube.com/channel/UCyqo4XTQlz57-ESk47V6tCg The cameras must shoot video for 3 seconds, wait 57 seconds and then repeat cycle. I manage fine if there is only one camera in front window (using a hacked Yoctop remote control). But when there are also cameras on the side windows, they often go out of sync and record for 57 seconds - that chews up precious SD card space. Therefore I need to address commands individually to each of the cameras, according to their status. I believe that I can do it with an ESP32 and a lot of learning from guys like you on Github. Thank you in advance. My first problem is with Secrets.h: // replace the following: #define GOPRO_1_SSID "*YOUR_CAMERA_NAME*" #define GOPRO_1_PASS "*YOUR_CAMERA_PASS*" // same for the second camera: #define GOPRO_2_SSID "*YOUR_CAMERA_NAME*" #define GOPRO_2_PASS "*YOUR_CAMERA_PASS*" If I look at GoPro Quik on my Android, I see for one of the Hero8's Name: GP53089464 Password: C>T-BNB-p4Q (I scrambled them slightly, but correct length and type of characters) Is it these names and passwords? Must it look like this? #define GOPRO_1_SSID "*GP53089464*" #define GOPRO_1_PASS "*C>T-BNB-p4Q*" — Reply to this email directly, view it on GitHub <#47>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AFBUBTQVLRRJCQTQ6RKTCJDX4L6SVANCNFSM6AAAAAA5H74OL4> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>