KNX Support : Latest commit in development branch introduced a regression when using DHT11 sensor about tasmota HOT 2 CLOSED

Thanks @pbrinette

In the meantime I have identified the reason
In the previous PR, I removed some code which was making the KNX driver limited to a short list of T&H sensor based on direct GPIO. My change would have allowed to support any T&H sensor including I2C sensors. Some configuration was done later, on the 1st Teleperiod.
But this was not counting on a configuration test performed at the start that was erasing the configuration if some GA was found for sensors that were not yet declared.

I already submit a PR #21378 where I remove totally the test.
I think this is safe to assume that if the user has configured a GA for a temperature sensor (or humidity), then he has connected such sensor.

from tasmota.

@pbrinette original behavior has now been reverted
That should solve your configuration erasure problem

from tasmota.