Use Wifi101 shield with Teensy 3.1 about wifi101 HOT 3 CLOSED

Hi @chensx2012,

I've submitted pull request #53 to get this library working with a Teensy 3.1. Please see #53 (comment) for the pin outs to use and the changes required to the current version of the library.

I've tested with the ScanNetworks and ConnectWithWPA examples.

cc/ @PaulStoffregen

from wifi101.

Hi @sandeepmistry
Thanks for your help, and now my Teensy 3.1 works with Wifi101. I have examined the scan networks and mac address. Later I found some other issues: 1) even after I connected a WPA wetwork, the WiFi.localIP() always return 0:0:0:0 (I checked the router management page, and saw the mac of the Wifi101 shield listed there), 2) for the firmware check example, it always showed Wifi shield: NOT PRESENT, and firmware version is "Err--"

from wifi101.

1. even after I connected a WPA wetwork, the WiFi.localIP() always return 0:0:0:0 (I checked the router management page, and saw the mac of the Wifi101 shield listed there)

I am not experiencing this. Do you have another Arduino board like the Uno to try this out with?

2. for the firmware check example, it always showed Wifi shield: NOT PRESENT, and firmware version is "Err--"

No issues with that example either, one note I have upgraded the f/w on my shield to 19.4.4. Here is the output I get:

WiFi101 firmware check.

WiFi101 shield: DETECTED
Firmware version installed: 19.4.4
Firmware version required : 19.4.4

Check result: PASSED

I would double check the wiring, I had to do it a few times when I setup things again today. Also, I am using the latest Teensy 1.28 release with Arduino IDE 1.6.8.

from wifi101.