Time estimate off by 25% about klipper_estimator HOT 9 CLOSED

.

from klipper_estimator.

Finger Nails.zip
I ended up having to print this in Cura, the difference wasn't as big as I was seeing in SuperSlicer, but still well outside the 1 min per 12 hours listed in the README.

Cura Estimate: 8:21
Klipper_Estimator: 10:20 (not including heat up times)
Actual Time: 10:01 (including ~4 mins heat up)

I hope that this gives you enough info to look into it further, but if you require anything else, please let me know. And thanks very much for making this utility available.

from klipper_estimator.

Hi @jrobbom5

Can you upload a config file as well? Without it, it's pretty much impossible for me to reproduce the issue.

Ideally both Klipper and estimator config, but definitely at least estimator config. You can use the dump-config command documented in the README.

Since both Cura and Superslicer are out by this much, I reckon it's probably something config related.

Best regards
Lasse

from klipper_estimator.

Hi Lasse,

Thanks very much for the reply. Sorry, I should have thought to include the config file. Here it is:
config.zip

Cheers, John

from klipper_estimator.

Thanks @jrobbom5, I'll look into the issue asap. It make take a little while, as I'm pretty swamped with other engagements currently. Sorry about that!

Best regards,
Lasse

from klipper_estimator.

Hi @jrobbom5

I was waiting for a print and decided to look at this quickly. Firmware retraction speeds weren't being honored. When re-running with the config and gcode you provided, I now get 9h55m7s down from 10h20m23s. This seems to be in line with the number you provided of 10h01m(with ~4 mins heatup).

I've uploaded a version 2.0.3, could you please test it out when you get a chance? :-)

Best regards,
Lasse

from klipper_estimator.

Hi Lasse,

Wow! Thanks so much for that, I will test it out shortly and let you know :)

Cheers, John

from klipper_estimator.

Hi @jrobbom5

Did you get a chance to test this?

Best regards,
Lasse

from klipper_estimator.

Hi @jrobbom5

I'll close this for now. If the problem persists, please ping me here or on Discord and we'll re-open :-)

Best regards,
Lasse

from klipper_estimator.